|
September 12th, 2005, 12:09 PM
|
#1 (permalink) |
 Join Date: Sep 2005
Posts: 1
 |
R3 to R6 ACS Upgrade- Straightforward?
I currently have a 12G2 R6 upgrade-backup card and was planning on using it on a R3.0.2 ACS processor. Is this a straightforward upgrade, or are there some risks or additional work that will be required?
Thanks for your help, Pete |
|
|
|
September 17th, 2005, 08:31 AM
|
#2 (permalink) |
|
Join Date: Sep 2005
Posts: 5
|
Re: R3 to R6 ACS Upgrade- Straightforward?
This is very straightforward. Power down, put upgrade card in, power on, watch the light on the processor as it goes through the upgrade, power down again when complete, power up and you are done. there should be no programming needed unless, you have battery issues. If you question their strength, replace with fresh AA's before you start the process. Good luck.
|
|
|
|
|
Advertisement
|
Sponsored links
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Definity Si R9.0 upgrade | gts | Definity Servers | 2 | August 29th, 2005 06:32 AM |
| upgrade | mugambi | Norstar systems | 0 | July 4th, 2005 05:41 AM |
| Upgrade to CM2 from v8 | MaltMan1 | Definity Servers | 13 | March 2nd, 2005 10:38 AM |
| Medpro Firmware Upgrade | Logix | Definity Servers | 6 | December 2nd, 2004 05:32 PM |
| acs dead after inserting remote access card | tek | Partner Systems | 2 | February 13th, 2004 11:09 PM |
Linear Mode
