sumesh

Hi,

Here I am installing CS 1000E with Rls 5.0 and networking the system with 11C and 61C with Rls 3.0. Here iam facing the the problem with , i am not able to get the ring back tone while i am calling to 61C but while calling to 11C i am getting ring back tone.Interfacing unit is Nortel Passport 7440 and the connectivity is 2mb LLC circuit.Connectivity between PBX and Passport is PRI and also using the same route for calling to 11c and 61C.Also Iam facing the problem with Name Displaying for incoming calls to CS 1000E

Can anybody help inthis regard

Cavscout

Sounds like you have a number of minor configuration issues.

1. Verify that the PBX programming to the 7400 is the same for each system.
2. Verify the 7400 programming is the same for each link, I assume there is a different Passport for each interface.
3. I think that if you compare the configuration of the 11c and 61c and then the 1000E you will not some configuration differences.

Finally... make sure you have the latest DEPLIST and MGC loadware.

PBXtech.info