|
January 4th, 2006, 07:58 AM
|
#1 (permalink) |
 Join Date: Jul 2004
Posts: 12
 |
Opt 11C to Definity G3V6R
Integrate a T-1 Pri pipe for 5 digit dialing from a new site (Meridian) to our old network system
(Avaya). I am on the G3 side. Set up and changed variables many times trying to activate signaling. Tru group always drops out ( out-of-service-NE ) using TN464F with 120A3 CSU. Any suggestions, research, pubs etc - - - I do not have Q-sig available on G3 equipment. |
|
|
|
February 13th, 2006, 09:15 AM
|
#2 (permalink) |
|
Join Date: Nov 2004
Posts: 5
|
Re: Opt 11C to Definity G3V6R
Do you have access to the Nortel system as well? If the parameters on both ends match the Pri should come up and you should see the D-channel active. How is your DS1 card programmed? I am not very good at the Nortel side but I will try.
|
|
|
|
|
Advertisement
|
Sponsored links
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Interface G3V6R with Meridian Opt 11C | acesys | Definity Servers | 2 | January 3rd, 2006 08:58 AM |
| Definity G3si V9 Calling Name Display | rcfoltz | Definity Servers | 1 | September 8th, 2005 11:07 AM |
| Calling Party Name Display - Opt 11C | badams500 | Meridian systems | 1 | January 31st, 2005 02:18 PM |
| IP office to Definity cont. | sgates | IP Office | 4 | December 22nd, 2004 02:01 PM |
| Definity One | Cephas | Definity Servers | 7 | May 3rd, 2004 02:06 PM |
Linear Mode
