surbratel

I try to put an private line on a M2616
every thing want fine I can get incoming call, and making calls out but after you make a call on that line and hang-up, that line keep hanging for almost 4 minute before disconnected
I move that line to another trunk TN and I still get the same thing

what can be the problem can someone give an atvice or please send me a setting of a private line thrunk

thanks
surbratel

p.s. sorry for my bad english

Ether

you might take a look at Disconnect Supervision On Loop Start Trunks

is it posible that the internal line hasn't dropped yet? does the trunk stay open after both parties hang up? that would be a ma bell issue.

PBXtech.info

 

samysp

Possibly you will need check the timers on Route Data, LD 16, TIMR where you configured this trunk.

Try to discrease the parameter DSI and EOD (Non-Digital Trunks). Normally it's work.


Good Luck!

surbratel

thanks
I will take a look at the timer on route data in ld 16
i think the problem is on the route data becouse the extention number work fine
no problem with that it's ownly yhe private line
anyway thanks for your advice i will try it

thanks again
surbratel

surbratel

hi
it's me again with another qustion
i have been with this for almost a week
if two phones on two separate tn are sharing one extention number, is there a privesie between them
one is an type 2616 and the other is an type 500

thanks
subratel

Ether

take a look at Please help a total newb!

that will give you a good idea of how the TN/DN linking works.

PBXtech.info

 

meridian911

I don't Know if I understand you correctly but try CLS = PVD = Privacy Denied
or PVA = Privacy allowed ... I am close on those class of service features I believe

Ether

CLS POD might be what you're looking for also

POA/POD = privacy Override Allow/Deny, POD prevents people from hearing a conversation that's already going on with Multiple Appearance DNs