l33byt

Ok guys. 2 Sites, 2 SOE.

I have 2 Useable IP's on each ADSL.
1 For router and 1 for Lan2 on SOE.
I can get internet access from each modem/router

I have the LIC on each site. And Valid.
I have NAT enabled on LAN1 & LAN2
I have an IP Route of 0.0.0.0 Sub 0.0.0.0 Gate 0.0.0.0 to LAN2
I have a valid IP Line with 3 VCM channels per site

Tunnel is IPSecTunnel
Local
IP Office LAN1 Address
SUB 255.255.255.255
LAN2 Address

Remote
Remote IP Office LAN1 Address
SUB 255.255.255.255
Remote LAN2 Address

I see loads of messages in monitor but I cannot ring accross sites. Am I doing some thing wrong.

Thanks

Phone dude

Is thisa through a WAN link? Here is a link to the knowledge base. I have never set one up.

IPSec over the WAN

I would think though, that the IP route should match the IP on the opposite system, not the 0.0.0.0. But not sure.

PBXtech.info