unable to administer unit

ten8ous1 · September 4th, 2004, 06:22 AM

anyone have an issue where they were unable to administer the ipoffice small office unit?

Any tips or trick to restore to default?

Thanks in advance,

big70 · September 4th, 2004, 11:54 AM

Look at the document and you can put in the defaults.

Greets Peter

Costas hadjipan · September 13th, 2004, 03:38 AM

From the DTE port (ipoffice) connect your pc and run the hyper terminal. The settings u should use, are VT 100 38400 8-N-1. After that write AT (enter) AT-X2 (enter) AT-X3 (enter).
Dont forget to switch off the system first.

Costas..

corhavelaar · September 13th, 2004, 01:53 PM

For defaulting IPO 2.1 also enter AT-X4.

If you cannot administer a IP Office over the LAN first try the dial-in option (if enabled), usually you can access the IP Office then, defaulting is always the last option i guess.

If you forgot the password try to find an old config and use the revelation software to retrieve the password, als you can check dial-in configuration.

September 4th, 2004, 06:22 AM	#1 (permalink)
ten8ous1 Join Date: Jul 2003 Posts: 16	unable to administer unit anyone have an issue where they were unable to administer the ipoffice small office unit? Any tips or trick to restore to default? Thanks in advance,

September 13th, 2004, 03:38 AM	#3 (permalink)
Costas hadjipan PBXtech SILVER 25+ posts Join Date: May 2004 Posts: 64	Re: unable to administer unit From the DTE port (ipoffice) connect your pc and run the hyper terminal. The settings u should use, are VT 100 38400 8-N-1. After that write AT (enter) AT-X2 (enter) AT-X3 (enter). Dont forget to switch off the system first. Costas..

September 13th, 2004, 01:53 PM	#4 (permalink)
corhavelaar PBXtech SILVER 25+ posts Join Date: Aug 2004 Posts: 81	Re: unable to administer unit For defaulting IPO 2.1 also enter AT-X4. If you cannot administer a IP Office over the LAN first try the dial-in option (if enabled), usually you can access the IP Office then, defaulting is always the last option i guess. If you forgot the password try to find an old config and use the revelation software to retrieve the password, als you can check dial-in configuration.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Unable to update to Pabx from OTM	maddy25	Meridian systems	0	August 18th, 2005 05:32 AM
Unable to run CCC reporting	rkurup	IP Office	2	June 23rd, 2005 10:49 AM
Avaya ASA and AT&T Data Service Unit	kik	Definity Servers	5	February 11th, 2005 11:33 AM
Manager cannot see the Control Unit	rookie	IP Office	3	September 17th, 2004 07:01 AM
Unable to receive voicemails	pharmaet	IP Office	2	August 6th, 2004 06:51 AM

Remove advertisements
PBXtech.info Advertisement	Sponsored links

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)