ruudsplint

We use a G700/S8300B with CM2.1 and have a problem with a MM720 (HW Vintage 5 FW Version 6). The configured BRI trunk went down and is not working even since.
Status bri-port and trunk-group are in-service. ISDN2 line is also ok.

But a trunk test gives a Error Code 8 on test 1251, meaning that the signaling link is down. I even replaced the MM720 board, but the problem stays.

How has any hint, tips to help ?????

List trace tac show the following:
16:54:33 Calling party station 680 cid 0x73
16:54:33 Calling Number & Name 680 Telefooncentr
16:54:33 dial 801
16:54:33 term trunk-group 1 cid 0x73
16:54:33 dial 801
16:54:33 seize trunk-group 1 member 1 cid 0x73
16:54:33 Calling Number & Name NO-CPNumber NO-CPName
16:54:43 denial event 1117: Outgoing trk seizure fail D1=0x7d D2=0x73
16:54:43 dial 8010455473066
16:54:43 reorder station 680 cid 0x73
16:54:45 idle station 680 cid 0x73

__________________
Ruud Splint
ruud.splint@imtech.nl
www.imtech.nl

lhngrb

try to set syn in G700

PBXtech.info

 

ruudsplint

Command: status bri-port 001v202
MG-001-1(configure)# show sync timing
SOURCE MM STATUS FAILURE
--------- ------------------- ----------------------- ---------------
Primary v2(2) Active(2) None
Secondary Not Configured
Local v0 Standby None
Active Source: v2 Sync Source Switching: Enabled

Command: status bri-port 001v202
STATUS BRI-PORT
Port: 001V202 Version:
Service State: in-service Active NCA-TSC Count: 0
Maintenance Busy?: no
Layer 1 State: activated

TEI Value Layer2 State Endpt Extension Endpt SPID Service SPID?
Link1 0 assigned
Link2
Link3

Command: status trunk 2
TRUNK GROUP STATUS
Member Port Service State Mtce Connected Ports
Busy
0002/001 001V202 out-of-service-NE no

Tried it, but as you can see, it didn't work.

__________________
Ruud Splint
ruud.splint@imtech.nl
www.imtech.nl