nstephens8

I am trying to get an IP trunk set up and after getting the ip-routes set up, the signaling group will not come up. I did a test on the signaling group and encountered a FAIL.

Port Maintenance Name Alt. Name Test No. Result Error Code

36 H323-SGR 1386 FAIL 1
36 H323-SGR 1392 PASS
36 H323-SGR 1387 PASS

Does anybody know what the 1386 failure is?

Thanks

liquidvw

Yea I found that one.

Test 386 error 1. Represents a failure of the clan hardware carrying the signaling group D channel. Check the errors against the clan bd maintenance object.

What happens when you status the singaling group on each end?

PBXtech.info

 

nstephens8

The signaling group on the near end reports out of service.

The far end...in service.

I did a test on the C-Lan and an ABORT occurred. Any ideas?


TEST RESULTS

Port Maintenance Name Alt. Name Test No. Result Error Code

01A12 CLAN-BD 52 PASS
01A12 CLAN-BD 598 PASS
01A12 CLAN-BD 600 PASS
01A12 CLAN-BD 601 PASS
01A1217 ETH-PT 1281 ABORT 0
01A1217 ETH-PT 1286 PASS
01A1217 ETH-PT 1282 PASS
01A1217 ETH-PT 1511 PASS

liquidvw

1281 looks like a ping test. Can you ping the clan from your PC or from another PBX?

Take a look at stat clan-port 01a1217. The clan might not be enabled or busyed.

nstephens8

Thanks liquid...

What is strange, now that I have taken the signaling group and moved it to my secondary CLAn, the CLAN in question tests fine.

I noticed that the install team has the CLAN set with Ethernet Option of Auto.

I am thinking I may want to hard code the Cisco and CLAN to Full/100.

Any thoughts?

My CLAN in another switch (G3Si V2.1) has the CLAN set to Half/10.

Should I just set to Half/10, full/100 or keep it auto?

liquidvw

Depends. The PBX setting must match your LAN switch. If there is a mismatch. ie PBX auto, LAN 10/half (or something like that) you will have problems. I allways have my Clan set to 100 full and the LAN switch set to 100 full. Once I have a mismatch, it caused some wired problems.

PBXtech.info