|
July 27th, 2005, 10:18 AM
|
#1 (permalink) |
 Join Date: Jun 2004
Posts: 1
 |
Calling Name Pass Through In ISDN IE
I have an S8710 running CM 2.2, and need to get the Calling Name (CNAM) on an incoming DID call over to another S8710. We're using UDP, and the call works just fine, and we see the Calling Number (CID) on the second PBX. We don't see the name though (we do see it if it terminates to an extension on the first PBX, where the ISDN DID trunks are), and we need to. What is different about the name in the IE from these telco trunks versus the QSIG ties between our PBX's? Could something not be setup correctly on the DID trunk group, or the route to the other PBX? Thanks.
|
|
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Denial Event 1164 | G3SIMAINT | Definity Servers | 7 | February 18th, 2006 08:31 AM |
| ISDN trunk configuration | mundoy_plana | Definity Servers | 11 | December 21st, 2005 05:09 AM |
| Delay in ISDN calls | JPWynn | Definity Servers | 0 | October 26th, 2005 01:18 PM |
| Definity G3si V9 Calling Name Display | rcfoltz | Definity Servers | 1 | September 8th, 2005 11:07 AM |
| SPN's Not working on Option 61c | niemannl | Meridian systems | 9 | April 11th, 2005 11:45 AM |
Linear Mode
