happyhammer

i have one VAL board and use VAL MGR. I'm using the VAL board to provide daily stock prices to callers so i have lots of announcements of very short durations (2 secs). i will probably need to add a second VAL board in 6 mths, my system capacity screen shows it can take 10 VAL boards, see below

Used Available Limit
-----------------------
Recorded Announcement Analog Queue Slots: 0 1000 1000
TN2501 VAL Boards: 1 9* 10
G700 VAL Sources: 0 10 10

My question. Is there any RTU/license limitation that would prevent me adding and using addtional VAL boards?

thx,

hammer
S8700,CMS2.1.1,

ahays

Yeah ... if "disp sys cu" says Total = 10 and Used = 1 then Available = 9. You should be good to go.

regs,

.al.

__________________
Al Hays, ACE, MCSE, CCNA
Homepage: http://www.jeral.com/
Training: http://www.jeral.com/avaya-learning.html

PBXtech.info

 

sparkee

You also need an RTU to enable the full hour and ten minutes of recording time on each VAL as they only have ten minutes available without RTU.

happyhammer

Are you saying that EACH VAL board needs an RTU for the full hour plus 10 mins ?
when i do a disp integr, i get the response below.

When i add my next VAL board, will it also have the 1 hour and ten mins? Where do i see the RTU per board?


Brd Tim Num Chk Brd Tim Num Chk
Loc Sfx Rem Rt Annc Sum Loc Sfx Rem Rt Annc Sum

1: 01A10 AP 3216 64 134 N/A 16:

thx, hammer

sparkee

On about page 4 of the system-parameter customer-options form, the field that says "TN2501 VAL Maximum Capacity", if this is set to no, then you will only have ten minutes of time per board. If this is set to yes, then you will have one hour and tem minutes for every board.