MaltMan1

I have a Transtalk 9031 and I've connected the transmitter to the wall and the line cord to the station jack. In my comms room I cross connected from the station port to the available digital port on a TN2224b circuit pack and have also tried it on a TN2224c digital circuit pack. When I click on/off on the phone I see the green lights all lit up on the transmitter and I just get this backround humm and no dialtone. I've tried a totally different phone and transmitter with the same result so I am eliminating the hardware being bad. I set the phone up as an 8410D.

Any ideas on what to try?

PBXBear

MaltMan-

I ran into the same issues with TransTalk - and after a few months of troubleshooting it with AVAYA on-site, and returning various components for RMA... we pulled the systems outs.

I know this isn't much assistance... My suggestions, pull the system out and install SpectraLink. IMHO, much easier to install, integrate & manager - not to mention superior performance and a lighter, smaller product.

-Chris

PBXtech.info

 

liquidvw

Has the handset been registed with the radio module? Have you button mapping for definty? I have a transtalk 9040, these 2 thing need to be done before the system will work.

Also, my transtalk frequently un registers with the radio module. It's a pain, but I only have one wireless phone in my office, so I deal with it.

MaltMan1

So what is the deal with Spectralink. The website looks pretty good, but as far as cost and time frame to get working... is it easy?

PBXBear

You'll pay a bit more with SpectraLink (I think it's worth it). I had to get a system installed in less then two weeks - internationially - they delviered. I've had nothing but great experiences with them.