|
August 19th, 2004, 05:29 PM
|
#1 (permalink) |
 Join Date: Jul 2003
Posts: 20
 |
Brief Ring on 6408+ bridged lines
Today I installed two 6408+ (no display) phones the secretary's phone #1 has two call appearances bridged to the boss phone #2 but when the call comes in for the boss on her bridged appearances her phone only rings briefly instead of the normal three rings when he does not pick up the call. They had two 8410d phones before I changed them out and they worked fine. Is this normal for this 6408+ set type?
Thanks Joaquin Telecom Admin Boeing San Antonio, TX
__________________
Joaquin |
|
|
|
August 19th, 2004, 05:49 PM
|
#2 (permalink) |
|
PBXtech SILVER 25+ posts
Join Date: Aug 2004
Posts: 30
|
Re: Brief Ring on 6408+ bridged lines
Check both stations parameters for Bridge call alerting to set to Y
Probably one of the stations has the SAC or the CallFwd feature active. Try out the command : Status station xxx to see this condition.. Thetris |
|
|
|
|
Advertisement
|
Sponsored links
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Automatic rerouting of outbound calls to POTS lines if T1 PRI goes down | chris0754 | IP Office | 1 | February 17th, 2006 11:57 AM |
| No ring tone on analog set (S8300) | savvasc | Definity Servers | 2 | January 18th, 2006 08:59 PM |
| BSR, Tie Lines & D-Channel | estallin | Definity Servers | 6 | January 17th, 2005 02:06 PM |
| Setting the Answer Lines status | Andrew | Norstar systems | 0 | July 18th, 2003 10:40 AM |
| Using Ring Again | Andrew | Norstar systems | 0 | July 8th, 2003 03:08 PM |
Linear Mode
