tek

I'm setting up a Definity and a Magix point to point. The Magix is set up as a PRI and set to Merlin Network.

I have the Definity DS1 card is set up as PRI, the trunk group is set to ISDN, and the signal group is. We're using the last 6 channels of the point to point.

I believe the problem is something we're not doing right on the Definity. What am I missing???

DUDE

"when connecting to a Definity ECS or Definity Prologix, the Definity must provision all 23 b-channels and allow Merlin legend to take out of service any b-channels that were dropped,
then Definity can unprovision those channels"
"Definity ECS and Definity Prologix Solutions systems use the interface field to specify the equivalent of a switch type. It identifies a slot on the local system as Network or User.
User is the usual setting. If the interface field specifies network, the Merlin Legend Communications Systems slot specifies Legend- Network. If the interface field specifies User, the Merlin Legend Communications Sytem specifies Legend-Pbx. Definity Ecs and Definity Prologix Solutions system documentation provides details about the interface field. "
Legend Communications System Network Reference/Network Reference
555-661-150/ 5-22,5-24

PBXtech.info