tschimpf

I have a system console I have lost the settings on, I cannot login to the system does anyone know the settings of the enter or return key. I can change the enter key to _cf_ _lf_ CRLF_ and the return key has a blank you type in. I can type in craft but I cannot get the password field up after hitting enter or return.

jroselle

Try powering off the SAT terminal and then back on. This might regain the original settings.

PBXtech.info

 

tschimpf

Problem is that I have had to replace my SAT console with one from a different site. My console we bad along with a tape drive.

jroselle

Try the ESCAPE and SPACEBAND key together to represent the ENTER KEY.

jroselle

See if this helps:



If the enter key on the System Access Terminal does not enter changes to a form.

Description:
The proper terminal emulation type must be selected. Type newterm and enter the correct terminal type. The SAT is normally a 715 and a remote terminal using an emulation is normally a 4410.

The enter key on a 715 GBCS-2 terminal must be programmed. To do so:

Press Ctrl & F1 at the same time
Press TAB key until Keyboard folder tab is highlighted.
Press gray down arrow and stop on Key Remapping
Press Enter
Press Enter/Chg Host key (Far right on the keyboard)
Press Esc (top left of keyboard)
Type SB (capitals)
Press gray down arrow stopping on Save/Exit
Press Enter
Press Ctrl & F1