redG

How do you upgrade the firmware for the VAL boards?

koelemon

Download the firmware from the Avaya support site, FTP it to the VAL board then schedule the board to update.

__________________
"There are only 10 types of people in the world,
those who can read binary and those that cannot."

PBXtech.info

 

ahays

Try This ...

regs,

.al.

Attached Files

TN Firmware Upgrade.pdf (697.0 KB, 38 views)

__________________
Al Hays, ACE, MCSE, CCNA
Homepage: http://www.jeral.com/
Training: http://www.jeral.com/avaya-learning.html

nexSIP

Here is a copy of the firmware also. I couldnt get it off the Avaya site directly.

Attached Files

tn2501ap_f7.zip (605.0 KB, 15 views)

cerby

Red G Your 2501ap card should have an rj 45 lan connection in the back of it. You need to go into your definity and type: ip-node-names
This will give your ip address for your val board. Then plug your network cable into your val and then into your lan. Go to start-run-type command. A dos window will appear with a flashing cursor.Type ping (whatever your val ip is) and you should get a reply. Then install a floppy in your drive and follow the directions for an FTP backup of your announcements. These directions are on Avaya.com

Hope this was helpfull

Later