PBXtech.info - View Single Post

David · April 29th, 2005, 01:53 PM

Does anyone have a problem in running the " TEST CNI c s " command in LD
135?

After we upgraded our PBX to Succession 3.0, we started doing the final
tests. One of the test is to run a test on the CNI cards. Well when I
ran the TEST on the CNI cards I waited for about 20 minutes until it
finally came back and failed the test. I then tried to run the test
again, but I could not because the PBX had now put itself into split
mode due to the test failing on the CNI cards. To bring it back
together we have to issue the "TEST CPU " command in LD 135.

Our PBX is an
-Option 81C
-Memory upgraded to 160 MB
-68060E CPU
-IODU/C Hard drive, floppy and CD drive.
-DEPLIST (patches) from 4/25/2005.

I have ran this test on our Option 61Cs' and have not come across this
problem.

We have a ticket open with Nortel, but I figured I would just bring
this to our group, to see if anyone has experienced this problem.

April 29th, 2005, 01:53 PM	#1 (permalink)
David PBXtech SILVER 25+ posts Join Date: Apr 2005 Posts: 29	Issuing the "TEST CNI" command in LD 135 Does anyone have a problem in running the " TEST CNI c s " command in LD 135? After we upgraded our PBX to Succession 3.0, we started doing the final tests. One of the test is to run a test on the CNI cards. Well when I ran the TEST on the CNI cards I waited for about 20 minutes until it finally came back and failed the test. I then tried to run the test again, but I could not because the PBX had now put itself into split mode due to the test failing on the CNI cards. To bring it back together we have to issue the "TEST CPU " command in LD 135. Our PBX is an -Option 81C -Memory upgraded to 160 MB -68060E CPU -IODU/C Hard drive, floppy and CD drive. -DEPLIST (patches) from 4/25/2005. I have ran this test on our Option 61Cs' and have not come across this problem. We have a ticket open with Nortel, but I figured I would just bring this to our group, to see if anyone has experienced this problem.