PBXtech.info - View Single Post

Logix · November 19th, 2004, 10:02 AM

Appologies - I was not trying to upgrade the clan , but upgrade the medpro " via the clan".
(However you have made a point, and I will have to by a few more clans)
I have since resolved this issue - and here is the fix (Took a bit of reading)

We installed a cisco 3500 with a mac address with on OUI of- XX-11-XX
As you may know the medpro boards below FW93 will not operate if connected/or connects via a device with an OUI of of xx-11-xx or xx-2E-xx. It would see devices on it's own subnet , but nothing else .
This was the real problem - Not being able to connect to the Medpro remotley , I tried to flash upgrade
via the clan - Which should have worked but didn't.
I ended up using TFTP from a device on the same subnet to load up FW46 to the medpro direct.
A board reset (Not a soft reset) loaded up FW 46 (Which although did not clear the fault), enabled me to
flash upgrade the medpro FW93 from the clan board. This resolved the fault... Phew

Now.. Off to buy some flash upgradeable Clan boards

Thanks

November 19th, 2004, 10:02 AM	#6 (permalink)
Logix PBXtech SILVER 25+ posts Join Date: Dec 2003 Posts: 38	Re: Medpro Firmware Upgrade Appologies - I was not trying to upgrade the clan , but upgrade the medpro " via the clan". (However you have made a point, and I will have to by a few more clans) I have since resolved this issue - and here is the fix (Took a bit of reading) We installed a cisco 3500 with a mac address with on OUI of- XX-11-XX As you may know the medpro boards below FW93 will not operate if connected/or connects via a device with an OUI of of xx-11-xx or xx-2E-xx. It would see devices on it's own subnet , but nothing else . This was the real problem - Not being able to connect to the Medpro remotley , I tried to flash upgrade via the clan - Which should have worked but didn't. I ended up using TFTP from a device on the same subnet to load up FW46 to the medpro direct. A board reset (Not a soft reset) loaded up FW 46 (Which although did not clear the fault), enabled me to flash upgrade the medpro FW93 from the clan board. This resolved the fault... Phew Now.. Off to buy some flash upgradeable Clan boards Thanks