PBXtech.info - View Single Post

fataldata · November 9th, 2004, 03:45 PM

Thanks all for the replies. I used the in Sys Parameters I have V12 and using the newterm option it shows load 411.

All of this is very helpful since my boss who bought the system in a remote location was told it was version 2.0 but from your info I am seeing that either it was upgraded or that info was erroneous.
Load 411 being CM2.1

Can't use the browser option since the IS side of the department practices a rather strict security policy restricting any web access to the pbx. This may change if I can convince them to simply set up routing policies which only allow some pc's to access the web page.

Thanks again.

November 9th, 2004, 03:45 PM	#5 (permalink)
fataldata PBXtech PLATINUM 300+ posts Join Date: Jul 2003 Posts: 315	Re: Command to display Comm Mgr version. Thanks all for the replies. I used the in Sys Parameters I have V12 and using the newterm option it shows load 411. All of this is very helpful since my boss who bought the system in a remote location was told it was version 2.0 but from your info I am seeing that either it was upgraded or that info was erroneous. Load 411 being CM2.1 Can't use the browser option since the IS side of the department practices a rather strict security policy restricting any web access to the pbx. This may change if I can convince them to simply set up routing policies which only allow some pc's to access the web page. Thanks again. __________________ Systems In Use: S8700 CM3.0 and S8710 CM3.1.1