PBXtech.info - View Single Post

rookie · September 15th, 2004, 03:58 PM

I connected IPO304 with my laptop through LAN. The UPLINK port 8 with button out is used to plug into wall. But the IPO manager cannot see the control unit. I have confirmed it is connected to LAN.

It works when I connect it to my laptop directly. I have tried to configure it. Everything works fine.
Then I want to try it on LAN; therefore, I erase config and connect to my Laptop through LAN. But the manager cannot see it.

There are several IP Office available on LAN. Using Manager I can three, but mine does not show up.

Any suggestions?

Thanks in advance.

rookie

September 15th, 2004, 03:58 PM	#1 (permalink)
rookie PBXtech SILVER 25+ posts Join Date: Sep 2004 Posts: 28	Manager cannot see the Control Unit I connected IPO304 with my laptop through LAN. The UPLINK port 8 with button out is used to plug into wall. But the IPO manager cannot see the control unit. I have confirmed it is connected to LAN. It works when I connect it to my laptop directly. I have tried to configure it. Everything works fine. Then I want to try it on LAN; therefore, I erase config and connect to my Laptop through LAN. But the manager cannot see it. There are several IP Office available on LAN. Using Manager I can three, but mine does not show up. Any suggestions? Thanks in advance. rookie Last edited by rookie; September 15th, 2004 at 04:20 PM.