PBXtech.info - View Single Post

jaiello2000 · July 8th, 2004, 12:50 PM

Been beating my head against the wall for some time.

I am connecting the G3 to a Cisco gateway. Done the Cisco GW many time to many PBXs. G3 is not making it easy. Also, am using a TPI PRI tester to check the PRI link...

The G3 is not bringing up the D channel. We have changes the config a hundred times, still no D Channel. T1 is up OK, Cisco transmits SABME, no RX. Can set T1 in remote loopbaclk and Cisco sees it's packets it is sending. Link looks OK...

Using the tester, no layer 2 established from G3. Not sure where to look or what to look for. Sees there is a disconnect between the DS1 curcuit pack and the D Chanel config.

BTW, card switch settings verified to 24 channels.

Any ideas?

Thanks

July 8th, 2004, 12:50 PM	#1 (permalink)
jaiello2000 Join Date: Jul 2004 Posts: 8	G3V6 TN464F PRI D Channel Problem Been beating my head against the wall for some time. I am connecting the G3 to a Cisco gateway. Done the Cisco GW many time to many PBXs. G3 is not making it easy. Also, am using a TPI PRI tester to check the PRI link... The G3 is not bringing up the D channel. We have changes the config a hundred times, still no D Channel. T1 is up OK, Cisco transmits SABME, no RX. Can set T1 in remote loopbaclk and Cisco sees it's packets it is sending. Link looks OK... Using the tester, no layer 2 established from G3. Not sure where to look or what to look for. Sees there is a disconnect between the DS1 curcuit pack and the D Chanel config. BTW, card switch settings verified to 24 channels. Any ideas? Thanks Last edited by jaiello2000; July 8th, 2004 at 01:01 PM.