Thread: Power Failure Station
View Single Post
Old January 31st, 2004, 08:41 AM   #4 (permalink)
ahays
Moderator
 
ahays's Avatar
 
Join Date: Jul 2003
Posts: 1,349
ahays will become famous soon enoughahays will become famous soon enough
Re: Power Failure Station
Quote:
Originally Posted by cerby
Can these be changed to loop start? My number to connect to my PBX is on this type of wall mount board as a member mentioned above. This was setup so that the PBX would report any major alarms to Avaya via the processor board. An Avaya tech said this is why the board was not reporting alarms. Since I have changed this from ground start to loop start I have received some outide calls on some of these emergency analog phones. Is this because it was changed from a ground start to a loop start?
The Emergency Transfer Panel can use either ground-start or loop-start trunks. It is selectable via a dip-switch. Complete instructions for installation can be found in Chapter 1 of the manual found at the following link: http://support.avaya.com/japple/css/...ss.UsageUpdate()

regs,

.al.
__________________
Al Hays, ACE, MCSE, CCNA
Homepage: http://www.jeral.com/
Training: http://www.jeral.com/avaya-learning.html
ahays is offline   Reply With Quote