Originally Posted by btrain8

I put this out there a while back and don't think I explained properly..

If a Call-FWD button is on the phone, it works fine..

when I display fac's-- the codes to activate and deactivate call-fwding are *2 and #2.

If I lift my handset and type in *2, after the first 2 digits following I get wave off. But on the same phone the call-fwd button works.. Below is my dialplan--

DIAL PLAN RECORD

Local Node Number: 5
ETA Node Number:
Uniform Dialing Plan: 4-digit ETA Routing Pattern:
UDP Extension Search Order: udp-table-first
FIRST DIGIT TABLE
First Length
Digit - 1 - - 2 - - 3 - - 4 - - 5 - - 6 -
1: fac extension
2: extension
3: extension
4: dac
5: extension
6: extension
7: fac
8: extension
9: fac
0: attd pextension
*: fac fac
#: fac