Quote:
|
Originally Posted by cimi
The units are not in the same building, they are about 15 miles apart. I have a point-to-point T1 that I want to use to connect them. Could you elaborate on 'Telephone number of 8N (not N)', I do not understand what that means.
If I were to use a PRI setting, would I have to set one system as CO and the other as CPE ?
Thanks
|
When you setup the shortcode 8XX, what did you put in the telephone number field? The short code dialog box should look like this:
Short code: 8XX
Telephone number: 8N
Line group ID: [the line group for your T1]
Feature: Dial
Locale: [blank]
To use PRI: I've not tried back to back over a CO supplied point to point, always done it with a crossover cable. However, the basic idea is setup both ends as required by the CO, but type "invert" in the telephone number field at one end.
Cephas