Thread: Tie line between IP offices
View Single Post
Old December 22nd, 2003, 07:45 PM   #2 (permalink)
nexSIP
Moderator
 
nexSIP's Avatar
 
Join Date: Jun 2003
Posts: 527
Blog Entries: 3
nexSIP is on a distinguished road
Re: Tie line between IP offices
Quote:
Originally Posted by cimi
Is it possible to connect 2 ip office's via a tie line? I have a point to point T1 and I plugged each end into the T1 card at each location and created a short code to dial on the appropriate line, but I was not able to get a call to go through. I had the lines set to E&M Tie and wink-start. I am trying this so I can avoid purchasing expensive VCM's.

Thanks
Mike
ive done this a few times.
make sure your short code is going out the proper trunk and the incoming routes are correct.
nexSIP is offline   Reply With Quote