mh613

Hello,
I have a software application that uses a dialogic d/240jct-t1 board connecting to a meridian 1 option 81c switch. I have been talking with the management of the switch and was finally able to get dnis down to my application by changing different parameters in the dialogic config file, the only problem I am having now is when my application hangs up the channel on the t1 the phone switch doesnt hang up and the application is sitting there with the channel tied up, but when the user hangs up the phone the call is disconnected cleanly. I am using a program called bitset from dialogic that shows me what is being sent for the abc and d bits and during the call a and b are showing on or 1s on both what the switch is sending me and what im sendning the switch. when the application hangs up the call i see that what im sending the switch switches to zeros or off and the switch is still sending me 1s, but when the end user of a phone calling in hangs up the switch goes to 0s and then so does what im sending the switch and the call is disconnected clean. the problem is that the site is telling me i need to give it a wink on a and b to disconnect, i can not find a way in the dialogic config file to send a wink on disconnect. most of our sites that have this set up have it so the phone switch simply disconnects when it sees a bit transition on a and b from 1s to zeros.

My main question is, is there a way to configure the meridian to hang up the call when it sees a bit transition from 1s to 0s on the a and b bits?