PBXtech.info - View Single Post

btrain2871 · May 1st, 2008, 07:57 AM

This may sound a bit confusing but bear with me..

I have a main site (s8700cm3.1) and then 2 small remote sites that are 1 block away from eachother (s8300/standalone). We have 4 digit dialing setup between each location via an IP trunk that goes back to the main site. the 2 small offices are consolidating into 1. Because of an MPLS network we have that carries our IP trunk traffic I had the DID's of the site that is moving ported over to the circuit at the other location even though the users aren't moving until next week. So what is happening now is the users still make outgoing calls off the PRI that the DID's were ported away from and any incoming call on those ported DID's are coming in at the other location.. seeing that range as a UDP/AAR entry and then routing to the main site over the IP trunk and then to the users. This is working perfect so far.

Next weekend the move of the users is to happen. Since the DID's are already ported do I just need to add the new stations at the 'TO' location and then remove the UDP/AAR entry and make sure in the dialplan that range is specified as an extension??

May 1st, 2008, 07:57 AM	#1 (permalink)
btrain2871 PBXtech PLATINUM 300+ posts Join Date: Mar 2006 Posts: 393	consolidating offices This may sound a bit confusing but bear with me.. I have a main site (s8700cm3.1) and then 2 small remote sites that are 1 block away from eachother (s8300/standalone). We have 4 digit dialing setup between each location via an IP trunk that goes back to the main site. the 2 small offices are consolidating into 1. Because of an MPLS network we have that carries our IP trunk traffic I had the DID's of the site that is moving ported over to the circuit at the other location even though the users aren't moving until next week. So what is happening now is the users still make outgoing calls off the PRI that the DID's were ported away from and any incoming call on those ported DID's are coming in at the other location.. seeing that range as a UDP/AAR entry and then routing to the main site over the IP trunk and then to the users. This is working perfect so far. Next weekend the move of the users is to happen. Since the DID's are already ported do I just need to add the new stations at the 'TO' location and then remove the UDP/AAR entry and make sure in the dialplan that range is specified as an extension??