Quote:
Originally Posted by btrain2871
Can anyone give any guidance on how to install a VAL Board for a CM 3.1 w/MCC cabinet? I have the board but don't know what to do other than insert it into an empty slot.
|
That's really all you need to do to use the board. However, if you want to be able to back-up/restore/etc. your announcement .WAV files then you'll also need to do the following:
1) Attach the black ethernet dongle to the amphenol connector and plug it into an ethernet port on your network that's locked at 100MB/Full.
2) "change node-name ip" and add the name and IP address
3) "add ip-i PPCCSS" where PPCCSS is the slot address of the board (i.e. 02A03) and complete the form. Under "Enable Ethernet port" make sure this is set to NO (we'll come back to that). Under "Ethernet Options" turn off auto and set to 100MB/Full.
4) "add data-module xxxx" where xxxx is a non-DID number in your dialplan. Type = ethernet, port = PPCCSS33 (i.e. 02A0333).
5) "change ip-i PPCSS" and enable the ethernet port.
6) Test using ping ... i.e. "ping ip 192.168.1.1 board 02A03 r 5"
7) You're done.
.al.