mh613

Hello, this might be an off the wall question. I have a T1 Dialogic card I am trying to configure for use with a TN767E DS1 Interface card Version 21 that is on a Definity G3si. The site is the owner of the phone system and I'm trying to match the settings he has on his cards with my Dialogic voice card. The site is saying they have no way to change anything and its not configurable at all. Ive been reading a few pdf's on what I can find out about their system and the TN767E card but cant make much sense of it. Basically I was wondering if anyone knew what the default settings were and how the bit signaling works. I need to tell my cards what to do to respond to their phone system but dont know what their system is expecting back to tell them we "picked up the call, you can stop ringing now". Currently I am seeing from them A bit is off and I'm seeing them flash the B bit from on to off then on and off again and on again when a call is coming through. I'm probably leaving some necessary information out so I will check back to see if anyone has any ideas or suggestions