View Single Post
Old January 31st, 2007, 08:42 PM   #1 (permalink)
sjforcum
PBXtech GOLD 100+ posts
 
sjforcum's Avatar
 
Join Date: Jul 2003
Posts: 109
sjforcum is on a distinguished road
Problem with 9630 Phone re-setting

Hi All,

Here's the situation:

I setup a site with 60+ 9630 IP Sets. One of the units is apparently re-booting once or twice a day. It is the only phone in this environment which is experincing this behavior.

What has been done to date:

* We changed the telephone. Same behavior
* We removed the station programming and re-built it.
* Confirmed firmware
* Moved to different LAN port
* Confirmed 100/Full settings on both ends
* Ran new cabling to office (it's the next office over from the comms room, so length isn't an issue)

Here's where I'm starting to point the finger...

We took the set, immediately after failure, and moved it to another physical location in the office space. It has not failed again since. However the replacement telephone we put in the gentleman's office with bridged appearances of the published extension HAS had the behavior re-occur.

I'm saying it's network related, although I can't point my finger at what.

Has anyone else run into something similar?

TIA,
SJF
sjforcum is offline   Reply With Quote