|
long distance via 1010 numbers
I have been working towards getting my video conferencing system to work over ISDN (supplied via a TN556C card in my switch) and as suggested in some other threads, my issue is now with my long distance carrier. They will not support the bandwidth requirements for video, but I want to keep them for voice calls. My idea is to use 1010xxx dialing from my video conferencing system to select a LD carrier that will handle video calls, but I have been unable to get it to work.
I dial 1010xxx-1-123-1234567 and I receive a "you must dial a 1 before the area code when you dial this number" message. The 1 is there when I dial, but it must be disappearing somewhere along the way. Here is my ars analysis:
ARS DIGIT ANALYSIS TABLE
Location: all Percent Full: 13
Dialed Total Route Call Node ANI
String Min Max Pattern Type Num Reqd
1010xxx 18 18 4 fnpa n
Here is route pattern 4:
Pattern Number: 4
Grp FRL NPA Pfx Hop Toll No. Inserted DCS/ IXC
No Mrk Lmt List Del Digits QSIG
Dgts Intw
1: 2 3 612 1 n user
2: n user
3: n user
4: n user
5: n user
6: n user
BCC VALUE TSC CA-TSC ITC BCIE Service/Feature BAND No. Numbering LAR
0 1 2 3 4 W Request Dgts Format
Subaddress
1: y y y y y n y as-needed bothept none
2: y y y y y n n rest none
3: y y y y y n n rest none
4: y y y y y n n rest none
5: y y y y y n n rest none
6: y y y y y n n rest none
I have also attached the above switch setting information in a text file because the text gets reformatted a bit in these posts and sometimes becomes hard to read.
I have a Definity G3csi V11 switch.
I would appreciate any suggestions. Thanks.
|