PBXtech.info - View Single Post

fataldata · February 13th, 2006, 02:18 PM

Here's the problem.

Have a Data Module configured stand alone (ie not attached to a station).
Type: x.25
Port: X
Baud: 9600
Edpoint Type: Adjunct
Link: Blank

For some reason I am unable to remove this Data Module. When I attempt to, I get an error msg that says 'Required Data Not Specified' and points at the Link field. So then I tried entering the Number of an unused comm-interface link, and when i try to enter the command I get and error message stating 'Error encountered, cannot complete request.'
I think next I might try to connect it to a physical port and see if that makes any difference. Any suggestions are greatly appreciated.

February 13th, 2006, 02:18 PM	#1 (permalink)
fataldata PBXtech PLATINUM 300+ posts Join Date: Jul 2003 Posts: 316	Trouble Removing a Data Module Here's the problem. Have a Data Module configured stand alone (ie not attached to a station). Type: x.25 Port: X Baud: 9600 Edpoint Type: Adjunct Link: Blank For some reason I am unable to remove this Data Module. When I attempt to, I get an error msg that says 'Required Data Not Specified' and points at the Link field. So then I tried entering the Number of an unused comm-interface link, and when i try to enter the command I get and error message stating 'Error encountered, cannot complete request.' I think next I might try to connect it to a physical port and see if that makes any difference. Any suggestions are greatly appreciated. __________________ Systems In Use: S8700 CM3.0 and S8710 CM3.1.1