Quote:
|
Originally Posted by rhwimmers
I can ping one just fine, but not the other. From my workstation and from the pbx itself... I get a fail error code 1007 on the one that fails. Both look identicle in the ip-interface other than their name and port obviously - Vlan is set to N - is their a way to change that? Is their any other way to back these up while I figure out what is wrong? Their is a com port on the back of the card too...I forget where the speed/duplex is set at but I remember checking and I believe its on auto or 100/full (it does match what our switch is on).
Thanks
Ross
|
If everything is programmed the same in the PBX, I would have a chat with the data guys to make certain the problem is not at the router, hub, switch, whatever they all connect through. The port of the one you cannot communicate with might be in a different network region, for example.