PBXtech.info - View Single Post

rhwimmers · January 31st, 2006, 06:46 AM

I can ping one just fine, but not the other. From my workstation and from the pbx itself... I get a fail error code 1007 on the one that fails. Both look identicle in the ip-interface other than their name and port obviously - Vlan is set to N - is their a way to change that? Is their any other way to back these up while I figure out what is wrong? Their is a com port on the back of the card too...I forget where the speed/duplex is set at but I remember checking and I believe its on auto or 100/full (it does match what our switch is on).
Thanks
Ross

January 31st, 2006, 06:46 AM	#3 (permalink)
rhwimmers PBXtech GOLD 100+ posts Join Date: Dec 2005 Posts: 102	Re: Backup for VAL board I can ping one just fine, but not the other. From my workstation and from the pbx itself... I get a fail error code 1007 on the one that fails. Both look identicle in the ip-interface other than their name and port obviously - Vlan is set to N - is their a way to change that? Is their any other way to back these up while I figure out what is wrong? Their is a com port on the back of the card too...I forget where the speed/duplex is set at but I remember checking and I believe its on auto or 100/full (it does match what our switch is on). Thanks Ross