Originally Posted by mindhijacker

i have a problem... i have installed and configured an new trunk. configured (trunk group, ds1 board and signalling goup). but i still can't recieve calls

Group Number: 2 Group Type: isdn-pri
Associated Signaling? y Max number of NCA TSC: 0
Primary D-Channel: 01A1716 Max number of CA TSC: 30
Trunk Group for NCA TSC: 2
Trunk Group for Channel Selection: 2 X-Mobility/Wireless Type: NONE
Supplementary Service Protocol: a Network Call Transfer? n

Location: 01A17 Name: Hot Site
Bit Rate: 2.048 Line Coding: hdb3
Signaling Mode: isdn-pri
Connect: network
TN-C7 Long Timers? n Country Protocol: etsi
Interworking Message: PROGress Protocol Version: b
Interface Companding: alaw CRC? y
Idle Code: 11111111
DCP/Analog Bearer Capability: 3.1kHz


Slip Detection? n Near-end CSU Type: other
Echo Cancellation? n

the status of the signalling group is always out of service, while the trunk status is in service (some times)
when i make calls to the trunk numbers from a land line, it rings in the speaker, but i don't see it on the phone set connected to the pbx. avaya s8700
i am from Egypt, we use E1s and etsi protocol.
your reply is highly appreciated.
regards