PBXtech.info - View Single Post

martinyoung · December 9th, 2005, 11:41 AM

I believe it changed to that command on 2.1 or 2.2. I do know that if you try the command I suggested on a switch that does not support it, you will get an error message that suggests using the new command. That is how I found out it changed.

Release number is very important because there can be drastic changes between releases. They still don't include a command I have been asking to have for two decades. The ability to busy and release a hunt group.

Since an LSP cannot be a higher release than the host switch, it is probably a 2.1 or 2.2.

Rhwimmer, if you are still out there, try Al's command instead.

December 9th, 2005, 11:41 AM	#5 (permalink)
martinyoung Moderator Join Date: Dec 2005 Posts: 1,445	Re: where to set CPNumber? I believe it changed to that command on 2.1 or 2.2. I do know that if you try the command I suggested on a switch that does not support it, you will get an error message that suggests using the new command. That is how I found out it changed. Release number is very important because there can be drastic changes between releases. They still don't include a command I have been asking to have for two decades. The ability to busy and release a hunt group. Since an LSP cannot be a higher release than the host switch, it is probably a 2.1 or 2.2. Rhwimmer, if you are still out there, try Al's command instead. __________________ Marty Retired Avaya DSIC tech